DMP 128 Plus
EUR
4680.00
€ 4680.00
Hersteller
Extron
Art.Nr.
60-1513-01
EAN
60-1513-01
Gewicht
3 kg
Produktbeschreibung
Hauptmerkmale
- Sechs Modelle mit 12 Mikrofon/Linepegel-Eingängen und 8 Ausgängen
- Alle Modelle besitzen eine USB-Audioschnittstelle für bis zu vier Kanäle für das Senden und Empfangen von digitalen Audiosignalen
- Neu Zwölf AEC-Kanäle (Acoustic Echo Cancellation) - Nur C?Modelle
- Neu Dante-Audiovernetzung mit Dante Domain Manager und AES67-Unterstützung für zahlreiche Erweiterungsmöglichkeiten - Nur AT?Modelle
- Bis zu acht VoIP-Leitungen unterstützen generische Session Initiation Protocol (SIP 2.0)-Verbindungen gemäß RFC 3261
- Die optionalen Audiobedienfelder der ACP-Serie für die intuitive Bedienung eines Audiosystems
Modell | Beschreibung der Version | Teilenummer | |
---|---|---|---|
DMP 128 Plus | 12x8 Prozessor mit ProDSP | 60-1511-01 | |
DMP 128 Plus AT | 12x8 Prozessor mit ProDSP und Dante | 60-1511-10 | |
DMP 128 Plus C | 12x8 Prozessor mit ProDSP und AEC | 60-1512-01 | |
DMP 128 Plus C AT | 12x8 Prozessor mit ProDSP, AEC und Dante | 60-1512-10 | |
DMP 128 Plus C V | 12x8 Prozessor mit ProDSP, AEC und VoIP | 60-1513-01 | |
DMP 128 Plus C V AT | 12x8 Prozessor mit ProDSP, AEC, VoIP und Dante | 60-1513-10 |
Technische Daten
Technische Daten
-
DMP 128 Plus Audio system Gain Balanced output: 0 dB, unbalanced output: -6 dB Frequency response 20 Hz to 20 kHz, ±0.2 dB THD + Noise <0.01%, 20 Hz to 20 kHz, at maximum level S/N Analog In to Analog Out >107 dB, 20 Hz to 20 kHz, at maximum balanced output (unweighted) Analog In to Digital Out 110 dB, 20 Hz to 20 kHz, at full-scale output (unweighted) Digital In to Analog Out 115 dB, 20 Hz to 20 kHz, at maximum balanced output (unweighted) Crosstalk <-90 dB @ 20 Hz to 20 kHz, fully loaded Volume control -100 dB to 0 dB (control 0 to 100 in 0.1 dB steps) Audio input Number/signal type 12 mono, mic/line, balanced/unbalanced, 8 with phantom power, 4 without phantom power Connectors (8) 3.5 mm captive screw, 3 pole, mono, balanced/unbalanced (with phantom power)
(2) 3.5 mm captive screw, 6 pole, mono, balanced/unbalanced (without phantom power)Impedance >10k ohms balanced/unbalanced Nominal level -60 dBV, +4 dBu, -10 dBV adjustable via input gain Maximum level +21 dBu at rated THD+N when mic gain is set to 0 dB Equivalent input noise <-120 dBV (1 µVrms) at 40 dB input gain CMRR >60 dB typical Input gain adjustment -18 dB to +80 dB in 0.1 dB steps, adjustable per input DC phantom power +48 VDC, +10% (inputs 1-8) can be switched on or off per input NOTE 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu; All nominal levels are at ±10% Audio output Number/signal type 8 mono (or 4 stereo), line, balanced/unbalanced Connectors (4) 3.5 mm captive screw, 6 pole, mono, balanced/unbalanced Impedance 100 ohms balanced, 50 ohms unbalanced Gain error ±0.1 dB channel to channel Maximum level (Hi-Z) >+21 dBu balanced, >+15 dBu unbalanced Audio processing A/D, D/A conversion 24-bit, 48 kHz AEC tail length >200 msec AEC convergence Up to 60 dB/sec Noise cancellation Up to 20 dB, software selectable EXP port Transmission type Proprietary Connector 1 RJ-45 Inputs 16 channels Rx Outputs 16 channels Tx Audio format Uncompressed, 24-bit, 48 kHz EXP cable Shielded CAT6 up to 10 meters (1 foot cable included) USB audio port Connector 1 rear panel USB mini-B USB standards USB 2.0, high speed AT ports (DMP 128 Plus AT models only) — audio transport Transmission type Dante/AES-67, software selectable Connectors 4 RJ-45, 4-port 1 Gbps switch to Dante interface Inputs 48 channels Rx Outputs 24 channels Tx Audio format Uncompressed, 24-bit, 48 kHz Latency Deterministic, based on user selections: 0.25 ms, 0.5 ms, 1.0 ms (default), 2.0 ms, 5.0 ms VoIP Port (DMP 128 Plus V models only) Connector 1 RJ-45 Data rate 10/100/1000 Base-T Signaling protocol Session Initiation Protocol (SIP), RFC 3261 and related RFCs Discovery protocol LLDP-MED (optional) Lines Up to 8 concurrent, independent extensions Codec support Various ITU, including wideband Default settings Link speed and duplex level = autodetected
IP address = 192.168.1.254
Subnet mask = 255.255.255.0
Default gateway = 0.0.0.0
DHCP = offControl/remote Serial host control port 1 bidirectional RS-232, 3.5 mm captive screw, 3 pole Baud rate and protocol 38400 baud, 8 data bits, 1 stop bit, no parity Pin configuration 1 = Tx, 2 = Rx, 3 = G USB control port 1 front panel USB mini-B USB standards USB 2.0, high speed ACP control port (1) 3.5 mm captive screw, 4 pole, supports up to 8 panels Pin configuration 1 = +12V, 2 = +S, 3 = -S, 4 = G Power supply 6 Watts max Digital I/O (8) 3.5 mm captive screw, 4 pole Pin configuration 1 = In, 2 = G, 3 = Out 1, 4 = Out 2 Voltage range Input = 0V to +12V
Output = 0V (low), 5V (high)
Software programmableEthernet host port 1 RJ-45 Data rate 10/100/1000 Base-T Protocol ARP, ICMP, IP, TCP, DHCP, HTTPS, Telnet Default settings Link speed and duplex level = autodetected
IP address = 192.168.254.254
Subnet mask = 255.255.255.0
Default gateway = 0.0.0.0
DHCP = offWeb server Up to 200 simultaneous sessions Program control Extron DSP Configurator control/configuration program for Windows®
Extron Simple Instruction Set (SIS™)
Microsoft® Internet Explorer®, TelnetGeneral Power supply Internal
Input: 100-240 VAC, 50-60 HzPower consumption and thermal dissipation DMP 128 Plus Power consumption 29.0 W Thermal dissipation 66.4 BTU/hr DMP 128 Plus C Power consumption 29.0 W Thermal dissipation 66.4 BTU/hr DMP 128 Plus AT Power consumption 32.1 W Thermal dissipation 77.0 BTU/hr DMP 128 Plus C V Power consumption 30.0 W Thermal dissipation 69.8 BTU/hr DMP 128 Plus C AT Power consumption 32.1 W Thermal dissipation 77.0 BTU/hr DMP 128 Plus C V AT Power consumption 32.4 W Thermal dissipation 78.0 BTU/hr Temperature/humidity Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensingCooling Fan, right to left (as viewed from the front panel), variable speed, OFF when ambient temperature is less than 40 °C Mounting Rack mount Yes, with included brackets Furniture mount Yes, with optional under-desk mounting kit Enclosure type Metal Enclosure dimensions 1.69" H x 17.40" W x 9.48" D (1U high, full rack wide)
(43 mm H x 442 mm W x 241 mm D)
(Depth excludes connectors)Product weight 4.5 lbs (2.1 kg) Regulatory compliance CE, c-UL, UL, CE, C-Tick, FCC Class A, ICES, VCCI, RoHS, WEEE Warranty 3 years parts and labor NOTE All nominal levels are at ±10%. NOTE Specifications are subject to change without notice (4030-D3)