DTP HD DA 4K 230

Technische Daten

DTP HD DA 4K 230 Series
specification — HDMI cables or DTP 4K/30 fps products without DisplayPort
Frame rate 1	24, 25, 30, 50, or 60 fps
Chroma sampling 1	4:4:4, 4:2:2, or 4:2:0
Color bit depth 1	8 bits per color
Signal type	HDMI 1.4, HDCP 1.4
Max. video data rate	10.2 Gbps (3.4 Gbps per color)
NOTE     1Subject to the maximum data rate limit. Use our calculator at www.extron.com/4Kdatarate to determine video parameters supported by this data rate.
Video
Maximum data rate	10.2 Gbps (3.4 Gbps per color)
Maximum pixel clock	300 MHz
Resolution range	Up to 2560x1600* @ 60 Hz or 4K (4096x2160) @ 30 Hz, UHD (3840x2160) @ 30 Hz, 4K/UHD @ 60 Hz with 4:2:0 chroma subsampling (*Reduced blanking)
Color bit depth	8, 10, or 12 bits — subject to the maximum data rate limit
Formats	RGB and YCbCr digital video
Standards	DVI 1.0, HDMI 1.4, HDCP 1.4, CEA-861E
Video input
NOTE     *Appropriate HDMI to DVI-D cables or adapters are required for HDMI signal input/output.
Number/signal type	1 single link HDMI (or DVI-D*)
Connectors	1 female HDMI type A
Video output
Number/signal type	1 single link HDMI (Local Output)
DTP HD DA4 4K 230	4 DTP 230
DTP HD DA8 4K 230	8 DTP 230
Interconnection between transmitter and receivers
Connectors
DTP HD DA4 4K 230	4 female RJ-45
DTP HD DA8 4K 230	8 female RJ-45
Termination standards	TIA/EIA T568B
Signal transmission distance
DTP HD DA4/DA8 4K 230
1080p @ 60 Hz	Up to 230' (70 m) using shielded twisted pair (STP) cable or XTP DTP 24 cable
2560x1600 @ 60 Hz	Up to 130' (40 m) using STP cable or XTP DTP 24 cable
4K/UHD @ 30 and 60 Hz	Up to 130' (40 m) using STP cable or XTP DTP 24 cable
Cable requirements	Solid conductor, 24 AWG or better
Cable recommendations	400 MHz bandwidth STP cable
NOTE     Extron XTP DTP 24 shielded twisted pair cable is strongly recommended for optimal performance.
NOTE     Output mode signaling: DTP:            HDMI with embedded audio, analog audio, RS-232 and IR, and remote power HDBaseT:    HDMI with embedded audio plus RS-232 and IR
Audio (analog audio)
Gain	Unbalanced output (from receiver): 0 dB; balanced output (from receiver): +6 dB
Frequency response	20 Hz to 20 kHz, ±1 dB
THD + Noise	0.03% @ 1 kHz; 0.3% @ 20 kHz at nominal level
S/N	>90 dB at maximum input (unweighted)
Stereo channel separation	>80 dB
Digital sampling rate	48 kHz
Bit depth	16 bit
Audio input (analog audio)
Number/signal type	1 PC level stereo, unbalanced
NOTE     Analog audio is not embedded onto the digital video signal. Analog audio and digital embedded audio are transmitted simultaneously and output on the receiver on two different connectors.
Connectors	(1) 3.5 mm stereo jack, 2 channel; tip (L); ring (R); sleeve (ground)
Impedance	>10k ohms, DC coupled
Nominal level	-10 dBV (316 mVrms)
Maximum level	+7 dBV, unbalanced
NOTE     0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu
Audio output
Number/signal type
Local output	1 PC level stereo, unbalanced
DTP output	4 or 8 embedded digital audio on DTP signal
Embedded digital audio source formats	2-ch PCM, PCM, Dolby Digital 2/0, Dolby Digital 2/0 Surround, Dolby Digital 5.1, Dolby Digital EX, DTS Digital Surround 5.1, DTS-ES Matrix 6.1 DTS-ES Discrete 6.1
Connectors
Local	(1) 3.5 mm stereo jack, 2 channel; tip (L), ring (R), sleeve (ground)
DTP	4 or 8 female RJ-45
Impedance	>50 ohms, DC coupled
Nominal level	-10 dBV (316 mVrms)
Maximum level	+6.5 dBV (unbalanced)
Control/remote
Serial control port	RS-232, 3.5 mm, 3 pole captive screw connector
Baud rate and protocol	9600 baud rate, 8 data bits, 1 stop bit, non-parity
Serial control pin configurations	Captive screw connectors: 1 = Tx, 2 = Rx, 3 = Gnd
USB control ports	1 front panel female mini USB B
USB standards	USB 2.0, low speed
Ethernet data rate	10/100Base-T, half/full duplex, with autodetect
Ethernet protocol	ARP, ICMP (ping), IP, TCP, DHCP, HTTP, Telnet, SMTP
Program control	Extron's Simple Instruction Set (SIS™), Extron Product Configuration Software (PCS), Microsoft Internet Explorer, Telnet
Communications — external device (RS-232/IR over TP)
Serial control port	RS-232 via (4) or (8) 3.5 mm, 5 pole captive screw connectors (connectors are shared with IR control ports)
Baud rate and protocol	300 to 115200 baud, 8 or 7 data bits, 1 or 2 stop bits, non-parity (default), even or odd parity
Serial control pin configuration	Captive screw connectors: 1 = Tx, 2 = Rx, 3 = Gnd
IR pass-through control port	(4) or (8) 3.5 mm, 5 pole captive screw connectors (connectors are shared with RS-232 control ports) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 60 kHz
IR control pin configuration	3 = Gnd, 4 = IR Tx, 5 = IR Rx
NOTE     Protocol is mirrored between the connected DTP 230 Rx or DTP 330 Rx endpoints and the "Over TP" ports on the DTP HD DA series. Signals from a control device pass into each "Over TP" port, are embedded with the DTP signal, and sent to the individual DTP 230 Rx or DTP 330 Rx endpoints for control of remote sink or source devices. The "Over TP" ports are simply pass-through connections to DTP endpoints. There is no RS-232 or IR insertion from any DA control port to the "Over TP" ports.
General
Power supply	Internal Input: 100-240 VAC, 50-60 Hz
Power consumption
DTP HD DA4 4K 230	45.6 watts
DTP HD DA8 4K 230	78.7 watts
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling	Convection, with vents
Thermal dissipation
DTP HD DA4 4K 230	85.5 BTU/hr
DTP HD DA8 4K 230	125 BTU/hr
Rack mount	Yes, with included rack ears
Enclosure type	Metal
Enclosure dimensions
DTP HD DA4 4K 230	1.75" H x 17.5" W x 10.6" D (1U high, full rack wide) (4.4 cm H x 44.4 cm W x 26.8 cm D, depth excludes connectors)
DTP HD DA8 4K 230	1.75" H x 17.5" W x 10.6" D (1U high, full rack wide) (4.4 cm H x 44.4 cm W x 26.8 cm D, depth excludes connectors)
Product weight
DTP HD DA4 4K 230	4.9 lbs (2.2 kg)
DTP HD DA8 4K 230	5.0 lbs (2.3 kg)
Vibration	ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance
Safety	CE, c-UL, UL
EMI/EMC	CE**, C-tick, FCC Class A**, ICES, VCCI
Environmental	Complies with the appropriate requirements of RoHS, WEEE
NOTE     **CE and FCC testing is conducted with STP cable.
Product warranty	3 years parts and labor
Everlast power supply warranty	7 years parts and labor
NOTE     All nominal levels are at ±10%.
NOTE     Specifications are subject to change without notice.
NOTE     Shipping dimensions and weights are available at http://www.extron.com.
(4064-080217)

Versand-Abmessung und -Gewicht
Teilenummer	Höhe	Breite	Tiefe	Gewicht
60-1437-01	11,4 cm	35,6 cm	55,9 cm	2,27 kg
60-1438-01	11,4 cm	35,6 cm	55,9 cm	2,27 kg