FOXBOX Rx DVI Plus
EUR
2556.00
€ 2556.00
Hersteller
Extron
Art.Nr.
60-1060-22
EAN
60-1060-22
Produktbeschreibung
Hauptmerkmale
- Verarbeitet Glasfasersignale von Sendern der FOX-Serie und liefert Single Link DVI-D-, Stereo-Audio- und RS-232-Steuerungssignale
- Vollständig digitale Technologie für eine pixelgenaue Übertragung von Signalen bis zu 1920x1200, einschließlich HDTV 1080p/60
- Kann einfach in zahlreiche 4K-Umgebungen integriert werden
- Kaskadierbar
- LED-Anzeigen für den Echtzeitstatus zur Fehlerbehebung und Überwachung
- Alarmmeldung bei Leitungsunterbrechung
Modell | Beschreibung der Version | Teilenummer | |
---|---|---|---|
FOXBOX Rx DVI Plus MM | Multimode - Empfänger | 60-1060-21 | |
FOXBOX Rx DVI Plus SM | Singlemode - Empfänger | 60-1060-22 |
Technische Daten
Technische Daten
-
FOXBOX Rx DVI Plus NOTE The analog audio signals are digitized in the transmitter, sent through the fiber cable, and converted back to analog audio in the receiver. NOTE This receiver is a class 1 laser product. It meets the safety regulations of IEC-60825, FDA 21 CFR 1040.10, and FDA 21 CFR 1040.11. Optical fiber interconnection between transmitter and receiver Number/type 1 or 2 fiber optic NOTE Only one fiber is required to transmit video, audio, and unidirectional data. A second fiber is required to transmit return data for bidirectional control/communication. Connectors 2 LC connectors Operating distance Singlemode 30 km (18.75 miles) with singlemode (SM) cables with a FOXBOX SM Multimode 300 m (985') with 62.5 µm OM1 multimode (MM) cables with a FOXBOX MM
1 km (3280') with 50 µm OM2 multimode (MM) cables with a FOXBOX MM
2 km (6561') with 50 µm OM3/OM4 2000 MHz bandwidth laser optimized multimode cable with a FOXBOX MMNOTE Operating distance is approximate. These are typical maximum distances that may vary depending on factors such as fiber type, fiber bandwidth, connector splicing, losses, modal or chromatic dispersion, environmental factors, and kinks. Nominal peak wavelength 850 nm for FOXBOX MM, 1310 nm for FOXBOX SM Data rate 4.25 Gbps Transmission power -5 dBm, typical Singlemode -5 dBm, typical Multimode Maximum receiver sensitivity Singlemode -18 dBm, typical Multimode -12 dBm, typical Optical loss budget Singlemode 13 dB, maximum Multimode 7 dB, maximum Video NOTE *Appropriate DVI-D to HDMI cables or adapters are required for HDMI signal input/output. The FOXBOX DVI Plus Series can be used to distribute HDMI signals if you use a DVI-to-HDMI adapter. However, when HDMI signals are used, these units do not transmit audio and CEC signals.
The FOXBOX DVI Plus does not support transmission of DVI signals with High-bandwidth Digital Content Protection (HDCP).Resolution range Up to 1920x1200 or 1080p @ 60 Hz pixel for pixel Formats RGB and YCbCr digital video Standards DVI 1.0, HDMI Video output Number/signal type 1 single link DVI-D (or HDMI*) Connectors 1 female DVI-I Nominal level 0.8 Vp-p Video delay 1-2 frames Audio Gain Range Adjustable, -18 dB to +10 dB Default Unbalanced output: 0 dB Frequency response 20 Hz to 20 kHz, ±0.5 dB THD + Noise 0.10% @ 1 kHz at nominal level S/N >80 dB at maximum output (unweighted) Audio bits per sample 18 bits per channel, 2 channels (L, R) Sampling rate 48 kHz Audio output Number/signal type 1 unbalanced stereo or 2 unbalanced mono Connectors (1) 3.5 mm mini stereo jack Impedance 50 ohms unbalanced Nominal level -10 dBV (316 mVrms) Maximum level (Hi-Z) +7.6 dBu, unbalanced at 1% THD+N Maximum level (600 ohm) >+6.3 dBu, unbalanced at 1% THD+N Audio delay 1.5 frames Control/remote Serial host control ports Control 1 RS-232, 2.5 mm mini stereo jack (front panel) Pass-through 1 RS-232, 3.5 mm captive screw connector, 5-pole (3 pins are used) (rear panel) Baud rate and protocol Control 9600 baud, 8 data bits, 1 stop bit, no parity Pass-through 9600 to 115,200 baud Serial control pin configuration Mini stereo jack: tip = Tx, ring = Rx, sleeve = GND Program control Extron control/configuration program for Windows®
Extron Simple Instruction Set (SIS™)General Power supply External
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 1 A, 12 wattsPower input requirements 12 VDC, 0.6 A Temperature/humidity Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensingCooling Convection, vents on top and side panels Thermal dissipation 3.9 BTU/hr Mounting Rack mount Yes, with optional rack shelf Furniture mount Yes, with optional under desk mounting kit Enclosure type Metal Enclosure dimensions 1.0" H x 4.3" W x 6.0" D (quarter rack wide)
(2.5 cm H x 10.9 cm W x 15.2 cm D)
(Depth excludes connectors.)Product weight 0.7 lbs (0.3 kg) per unit Shipping weight 3 lbs (2 kg) per unit Vibration ISTA 1A in carton (International Safe Transit Association) Regulatory compliance Safety CE, c-UL, FDA Class 1, UL EMI/EMC CE, C-tick, FCC Class A, ICES, VCCI Product warranty 3 years parts and labor Everlast power supply warranty 7 years parts and labor NOTE All nominal levels are at ±10%. NOTE Specifications are subject to change without notice. (8.0-083012-D1) Versand-Abmessung und -Gewicht Teilenummer Höhe Breite Tiefe Gewicht 60-1060-21 6,4 cm 31,3 cm 22,2 cm 1,04 kg 60-1060-22 7,0 cm 22,9 cm 34,3 cm 1,0 kg