DTP R DP 4K 230

Technische Daten

DTP T/R DP 4K 230
specification
Frame rate 1	24, 25, 30 fps
Chroma sampling 1	4:4:4 or 4:2:2
Color bit depth 1	8 bits per color
Signal type	DisplayPort, HDCP
Max. video data rate	10.8 Gbps (2.7 Gbps per lane)
NOTE     1Subject to the maximum data rate limit. Use our calculator (http://www.extron.com/product/videotools.aspx) to determine video parameters supported by this data rate.
NOTE     This product consists of a transmitter (DTP T DP 4K 230) and a receiver (DTP R DP 4K 230), sold separately, with a twisted pair cable linking the transmitter and receiver.
Video
Maximum data rate	Up to 10.8 Gbps (2.7 Gbps per lane)
Maximum pixel clock	300 MHz
Resolution range	Up to 2560x1600* @ 60 Hz or 4K (4096x2160) @ 30 Hz, UHD (3840x2160) @ 30 Hz (* reduced blanking)
Color bit depth	8, 10, or 12 bits — subject to the maximum data rate limit
Formats	RGB and YCbCr digital video
Standard	DisplayPort 1.2, HDCP 1.4
NOTE     Only Single Stream Transport (SST) is supported.
Video input — transmitter
Number/signal type	1 DisplayPort
Connector	1 female DisplayPort
Interconnection between transmitter and receiver
Signal type	DTP 230
Connector	1 female RJ-45 per unit
Termination standard	TIA/EIA T568B
Signal transmission distance
1080p @ 60 Hz	Up to 230' (70 m) using shielded twisted pair (STP) cable or XTP DTP 24 STP cable
2560x1600 @ 60 Hz	Up to 130' (40 m) using shielded twisted pair (STP) cable or XTP DTP 24 STP cable
4K/UHD @ 30 Hz	Up to 130' (40 m) using shielded twisted pair (STP) cable or XTP DTP 24 STP cable
Cable requirements	Solid conductor, 24 AWG or better
Cable recommendations	400 MHz bandwidth, STP (shielded twisted pair)
NOTE     Extron XTP DTP 24 shielded twisted pair cable is strongly recommended for optimal performance.
NOTE     Input and output mode signaling: DTP:             HDMI with embedded audio, analog audio, RS-232 and IR, and remote power HDBaseT:   HDMI with embedded audio plus RS-232 and IR
Video output — receiver
Number/signal type	1 DisplayPort
Connectors	1 female DisplayPort
Audio
Gain	Unbalanced output: 0 dB; balanced output +6 dB
Frequency response	20 Hz to 20 kHz, ±0.5 dB
THD + Noise	0.03% @ 20 Hz to 20 kHz at maximum output
S/N	>90 dB, at maximum input (unweighted)
Stereo channel separation	>80 dB
Digital sampling	48 kHz
Bit depth	16 bit
Audio input
Signal type
Analog audio (over DTP)	Stereo (2 channel), balanced/unbalanced
NOTE     Analog audio is not embedded onto the DisplayPort signal.  Embedded digital audio is not de-embedded from the DisplayPort signal.
Digital audio	Embedded digital audio on DTP signal
Embedded digital audio source formats	2-ch PCM, PCM, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS Digital Surround 5.1, DTSES Matrix 6.1, DTS-ES Discrete 6.1
Connector	(1) 3.5 mm stereo jack, 2 channel; tip (L), ring (R), sleeve (ground)
Impedance	>10k ohms, DC coupled
Nominal level	-10 dBV (316 mVrms)
Maximum level	+7 dBV (unbalanced)
NOTE     0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu
Audio output
Signal type
Analog audio (over DTP)	Stereo (2 channel), balanced/unbalanced
NOTE     Analog audio is not embedded onto the DisplayPort signal.  Embedded digital audio is not de-embedded from the DisplayPort signal.
Digital audio	Embedded digital audio on DTP signal
Embedded digital audio source formats	2-ch PCM, PCM, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS Digital Surround 5.1, DTSES Matrix 6.1, DTS-ES Discrete 6.1
Impedance	50 ohms unbalanced, 100 ohms balanced
Gain error	±0.2 dB channel to channel
Maximum level (600 ohm)	>+14 dBu, balanced
Connectors
Digital audio	Female DisplayPort
Analog audio	(1) 3.5 mm captive screw connector, 5 pole
Communication — external device (pass-through, unidirectional or bidirectional)
Serial control port input/output
Transmitter	RS-232 via (1) 3.5 mm, 5 pole captive screw connector for RS-232 control (±5 V) (connector is shared with IR control port)
Receiver	1 set of proprietary signals on a female RJ-45 jack
Serial control port output/input
Transmitter	1 set of proprietary signals on a female RJ-45 jack
Receiver	RS-232 via a 3.5 mm, 3 pole captive screw connector
Baud rate and protocol	300 to 115200 baud, 8 or 7 data bits, 1 or 2 stop bits, non-parity (default), even or odd parity
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = Gnd
IR control port	(1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 60 kHz
IR control pin configuration	3 = Gnd, 4 = IR Tx, 5 = IR Rx
General
Power supply	External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1.5 A, 18 watts
Power consumption
Transmitter
Device	3.4 watts, 12 VDC
Device and power supply	4.5 watts, 100-240 VAC, 50-60 Hz
Receiver
Device	5.2 watts, 12 VDC
Device and power supply	6.6 watts, 100-240 VAC, 50-60 Hz
NOTE     Each transmitter or receiver can be powered either locally by an external power supply or remotely by receiver or transmitter on the other end of the twisted pair cable.
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling	Convection, no vents
Thermal dissipation
Transmitter
Device	11.1 BTU/hr
Device and power supply	16.8 BTU/hr
Receiver
Device	18.1 BTU/hr
Device and power supply	25.4 BTU/hr
Mounting
Rack mount	Yes, with optional 1U high rack shelf
Furniture mount	Yes, with optional under-desk mounting kit
Enclosure type	Metal
Enclosure dimensions
Transmitter	1.0" H x 4.3" W x 6.0" D (quarter rack wide) (2.5 cm H x 10.9 cm W x 15.2 cm D) (Depth excludes connectors.)
Receiver	1.0" H x 4.3" W x 6.0" D (quarter rack wide) (2.5 cm H x 10.9 cm W x 15.2 cm D) (Depth excludes connectors.)
Product weight
Transmitter	0.5 lbs (0.3 kg)
Receiver	1.0 lb (0.5 kg)
Regulatory compliance	CE, c-UL, UL, CE**, C-tick, FCC Class A**, ICES, VCCI
Product warranty	3 years parts and labor
Everlast power supply warranty	7 years parts and labor
NOTE     All nominal levels are at ±10%.
NOTE     Specifications are subject to change without notice.
(4325-083118-D12)

Versand-Abmessung und -Gewicht
Teilenummer	Höhe	Breite	Tiefe	Gewicht
60-1076-23	6,0 cm	19,1 cm	14,9 cm	0,36 kg
60-1076-13	6,0 cm	19,1 cm	14,9 cm	0,36 kg