DTP T DSW 4K 333

Technische Daten

DTP T DSW 4K Series
specification
Frame rate 1	24, 25, 30, 502, or 602 fps
Chroma sampling 1	4:4:4, 4:2:2, or 4:2:02
Color bit depth 1	8 bits per color
Signal type 1	HDMI 1.4 , DisplayPort 1.1a, HDCP 1.4
Max. video data rate 1
HDMI	10.2 Gbps (3.4 Gbps per color)
DisplayPort	10.8 Gbps (2.7 Gbps per lane)
NOTE     1Subject to the maximum data rate limit. Use our calculator (www.extron.com/4Kdatarate) to determine video parameters supported by this data rate. 2Applicable to HDMI signals only.
Video
VGA input
Gain	Unity
Bandwidth	170 MHz (-3 dB)
Crosstalk	-50 dB @ 10 MHz, -30 dB @ 100 MHz
HDMI input
Maximum data rate	10.2 Gbps (3.4 Gbps per color)
Maximum pixel clock	300 MHz
Resolution range	Up to 2560x1600* @ 60 Hz or 4K (4096x2160) @ 30 Hz, UHD (3840x2160) @ 30 Hz, 4K/UHD @ 60 Hz with 4:2:0 chroma subsampling (*Reduced blanking)
Formats	RGB and YCbCr digital video
Standards	DVI 1.0, HDMI 1.4, HDCP 1.4, CEA-861E
DisplayPort input
Maximum data rate	10.8 Gbps (2.7 Gbps per lane)
Maximum pixel clock	300 MHz
Resolution range	Up to 2560x1600* @ 60 Hz or 4K (4096x2160) @ 30 Hz (*Reduced blanking)
Formats	RGB and YCbCr digital video
Standards	DisplayPort 1.1a
Video input
Number/signal type
VGA input	1 VGA-WUXGA RGBHV
HDMI input	1 single link HDMI (or DVI-D*)
DisplayPort input	1 DisplayPort
NOTE     *Appropriate HDMI to DVI-D cables or adapters are required for DVI signal input/output.
Connectors
VGA input	1 female 15-pin HD
HDMI input	1 female HDMI, type A
DisplayPort input	1 female DisplayPort
VGA input
Nominal level	1.0 Vp-p
Minimum/maximum levels	Analog 0.3 V to 1.5 Vp-p with no offset
Impedance	75 ohms
Horizontal frequency	15 kHz to 145 kHz
Vertical frequency	30 Hz to 170 Hz
Return loss	<-40 dB @ 5 MHz
Video output
Number/signal type
DTP T DSW 4K 233	1 DTP 230 (output)
DTP T DSW 4K 333	1 DTP 330 (output)
Interconnection between transmitter and receiver
Connectors	1 RJ-45 jack
Termination standards	TIA/EIA T568B
DTP signal
Signal transmission distance
DTP T DSW 4K 233
1080p @ 60 Hz	Up to 230' (70 m) using shielded twisted pair (STP) cable or XTP DTP 24 cable
2560x1600 @ 60 Hz	Up to 130' (40 m) using STP cable or XTP DTP 24 cable
4K/UHD @ 30 and 60 Hz	Up to 130' (40 m) using STP cable or XTP DTP 24 cable
DTP T DSW 4K 333
1080p @ 60 Hz	Up to 330' (100 m) using shielded twisted pair (STP) cable or XTP DTP 24 cable
2560x1600 @ 60 Hz	Up to 330' (100 m) using STP cable or XTP DTP 24 cable
4K/UHD @ 30 and 60 Hz	Up to 330' (100 m) using STP cable or XTP DTP 24 cable
Cable requirements	Solid conductor, 24 AWG or better
Cable recommendations	400 MHz bandwidth STP cable
NOTE     Extron XTP DTP 24 shielded twisted pair cable is strongly recommended for optimal performance.
NOTE     Output mode signaling: DTP:             HDMI with embedded audio, analog audio, RS-232 and IR, and remote power HDBaseT:   HDMI with embedded audio plus RS-232 and IR
Sync — VGA
Input type	RGBHV, bi-level and tri-level sync
Input level	1.9 V to 5.0 Vp-p
Input impedance	510 ohms
Max. input voltage	5.0 Vp-p
Audio
Frequency response	20 Hz to 20 kHz, ±0.5 dB
THD + Noise	0.03% @ 1 kHz at nominal level
S/N	>90 dB at maximum input (unweighted)
Stereo channel separation	>80 dB @ 1 kHz
Audio input
Number/signal type	1 stereo, unbalanced
Connectors	(2) 3.5 mm stereo jack, 2 channel; tip (L); ring (R); sleeve (Gnd)
Impedance	>10k ohms, DC coupled
Nominal level	-10 dBV (316 mVrms)
Maximum level	+6 dBV, unbalanced
NOTE     0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu
Control/remote — switcher
Serial control port	RS-232 via 1 rear panel 3.5 mm, 3-pole captive screw connector
Pin configuration	1 = Tx, 2 = Rx, 3 = Gnd
Baud rate and protocol	9600 baud rate, 8 data bits, 1 stop bit, no parity
Contact closure	(1) 3.5 mm, 4-pole captive screw connector
Pin configuration	Pin 1 = input 1 contact, Pin 2 = input 2 contact, Pin 3 = input 3 contact, Pin 4 = Gnd
Tally output	(1) 3.5 mm, 4-pole captive screw connector
Pin configuration	Pin 1 = input 1 tally ground, Pin 2 = input 2 tally ground, Pin 3 = input 3 tally ground, Pin 4 = +5 V
USB control port	1 front panel female mini USB B
USB standards	USB 2.0, low speed
Program control	Extron Simple Instruction Set (SIS™)
Control/remote — external device (RS-232/IR over TP)
NOTE     Protocol is mirrored between the connected DTP 230 Rx or DTP 330 Rx endpoints and the "Over TP" ports on the DTP T DSW 4K series. Signals from a control device pass into each "Over TP" port, are embedded with the DTP signal, and sent to the individual DTP 230 Rx or DTP 330 Rx endpoints for control of remote sink or source devices. The "Over TP" ports are simply pass-through connections to DTP endpoints. There is no RS-232 or IR insertion from any DTP T DSW 4K control port to the "Over TP" ports.
Serial control port	Bidirectional RS-232 via 1 rear panel 3.5 mm, 5-pole captive screw connector (connector is shared with IR control ports)
Baud rate and protocol	300 to 115200 baud, 8 or 7 data bits, 1 or 2 stop bits, non-parity (default), even or odd parity
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = Gnd
IR pass-through control port	1 bidirectional rear panel 3.5 mm, 5-pole captive screw connector (connector is shared with RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 60 kHz
IR control pin configuration	3 = Gnd, 4 = IR Tx, 5 = IR Rx
General
Power supply	External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 2 A, 24 watts
NOTE     This product requires a locally connected power supply. It can provide remote DC power to a connected DTP receiver over twisted pair.
Power consumption
Device
DTP T DSW 4K 233	11.4 watts
DTP T DSW 4K 333	12.0 watts
Device and power supply
DTP T DSW 4K 233	14.1 watts
DTP T DSW 4K 333	14.7 watts
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling	Convection, no vents
Thermal dissipation
Device
DTP T DSW 4K 233	22.7 BTU/hr
DTP T DSW 4K 333	24.4 BTU/hr
Device and power supply
DTP T DSW 4K 233	32.0 BTU/hr
DTP T DSW 4K 333	33.6 BTU/hr
Rack mount	Yes, with optional rack shelf kit
Enclosure type	Metal
Enclosure dimensions	1.0" H x 8.75" W x 6.0" D (1" high, half rack wide) 2.5 cm H x 22.2 cm W x 15.2 cm D (depth excludes connectors)
Product weight	1.1 lbs (0.5 kg)
Vibration	ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance
Safety	CE, c-UL, UL
EMI/EMC	CE**, C-tick, FCC Class A**, ICES
Environmental	Complies with the appropriate requirements of RoHS, WEEE
NOTE     **CE and FCC testing is conducted with STP cable.
Product warranty	3 years parts and labor
Everlast power supply warranty	7 years parts and labor
NOTE     All nominal levels are at ±10%.
NOTE     Specifications are subject to change without notice.
NOTE     Shipping dimensions and weights are available at http://www.extron.com.
(8.1-071116-D3)

Versand-Abmessung und -Gewicht
Teilenummer	Höhe	Breite	Tiefe	Gewicht
60-1487-52	12,1 cm	28,1 cm	24,5 cm	1,32 kg