FOX T UWP 302

Technische Daten

FOX T UWP 302
NOTE     The FOX T UWP 302 is not compatible with the FOX 3G HD-SDI, FOX 3G DVC, or FOX AV models.
NOTE     These units are class 1 laser products. They meet the safety regulations of IEC-60825.
NOTE     *Appropriate HDMI to DVI-D cables or adapters are required for DVI signal input/output.
Optical fiber interconnection between transmitter and receiver
Number/type	1 or 2 fiber optic
Connectors	2 LC connectors
Operating distance
Singlemode	30 km (18.75 miles) with singlemode (SM) cables
Multimode	300 m (984') with 62.5 µm OM1 multimode (MM) cables 1 km (3280') with 50 µm OM2 multimode (MM) cables 2 km (6561') with 50 µm OM3/OM4 2000/4700 MHz bandwidth laser optimized multimode cables
NOTE     Operating distance is approximate. These are typical maximum distances that may vary depending on factors such as fiber type, fiber bandwidth, connector splicing, losses, modal or chromatic dispersion, environmental factors, and kinks.
Nominal peak wavelength	850 nm for MM, 1310 nm for SM
Data rate	4.25 Gbps
Maximum pixel clock	165 MHz
Transmission power
Singlemode	-5 dBm, typical
Multimode	-5 dBm, typical
Maximum receiver sensitivity
Singlemode	-18 dBm, typical
Multimode	-12 dBm, typical
Optical loss budget
Singlemode	13 dB, maximum
Multimode	7 dB, maximum
Video
Digital
Resolution range	640x480 up to 1920x1200, 480p, 576p, 720p, 1080i, 1080p @ 60 Hz sampled pixel for pixel; higher resolution 2K (2048x1080) @ 60 Hz undersampled
Resolution range	640x480 to 1920x1200*, 480p, 576p, 720p, 1080i, 1080p sampled pixel for pixel
Formats	RGB and YCbCr digital video
Standards	DVI 1.0, HDMI compliant, HDCP 1.1, CEA-861E
Analog
Maximum resolution	Up to 1920x1200 or 1080p @ 60 Hz pixel for pixel
Signal type	VGA-UXGA RGBHV, RGBS, component video
Gain	Unity
Pixel data bit depth	8 bits per channel, 3 channels (R, G, B; or YUV)
Video input
Digital
Number/signal type	1 single link HDMI (HDCP compliant)
Connectors	1 female 19-pin HDMI Type A
Equalization	Up to 50' of cable
Analog
Number/signal type	1 VGA-UXGA RGBHV, RGBS, component video (YUVp/HDTV)
Connectors	1 female 15-pin HD
Nominal level	1 Vp-p for Y of component video 0.7 Vp-p for RGB and for R-Y and B-Y of component video
Minimum/maximum levels	Analog: 0.3 V to 0.75 Vp-p with no offset, terminated
Impedance	75 ohms
Horizontal frequency	30 kHz to 100 kHz
Vertical frequency	24 Hz to 120 Hz
Return loss	<-40 dB @ 5 MHz
Sync
Input type	RGBHV, RGBS, bi-level and tri-level component video (480p, 576p, 720p, 1080i, 1080p)
Input level	2.5 V to 5.0 Vp-p for RGBHV or RGBS 0.6 Vp-p for component video with tri-level sync 0.3 Vp-p for component video with bi-level sync
Input impedance	510 ohms
Polarity	Positive or negative (follows input or can be set by user)
Audio
Gain
Range	Adjustable, -18 dB to +10 dB
Default	Unbalanced output: -6 dB
Frequency response	20 Hz to 20 kHz ±0.5 dB
THD + Noise	0.10% @ 1 kHz at nominal level
S/N	>80 dB at maximum output (unweighted)
Audio bits per sample	18 bits per channel, 2 channels (L, R)
Sampling rate	48 kHz
Audio input
Number/signal type	1 unbalanced stereo
Connectors	(1) 3.5 mm mini stereo jack
Impedance	>10k ohms unbalanced
Nominal level	-10 dBV (316 mVrms)
Maximum level	+7 dBV unbalanced
NOTE     0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu
Communications
Serial control port
Control	1 RS-232, 3.5 mm captive screw connector, 5 pole (3 pins are used, "Remote RS-232", shared with alarm port), side panel
Baud rate and protocol	9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = GND
USB control port	1 front panel female mini USB B
USB standards	USB 2.0, low speed
General
Power supply	External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1.5 A, 18 watts
Power consumption
Device	6.1 watts, 12 VDC
Device and power supply	7.7 watts, 100-240 VAC, 50-60 Hz
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +104 °F (0 to +40 °C) / 10% to 90%, noncondensing
Cooling	Convection, vents on the rear and sides
Thermal dissipation
Device	20.6 BTU/hr
Device and power supply	26.2 BTU/hr
Mounting
Furniture or wall mount	Yes, with standard decorator-style wall plate
Enclosure type	Metal
Enclosure dimensions
Faceplates	Three [2.6" H* x 1.3" W x 0.3" D (6.6 cm H* x 3.3 cm W x 0.6 cm D)] (Depth excludes connectors. Fits the openings in a 3 gang decorator-style wallplate.) *Overall height is 4.1" (10.4 cm) including mounting tabs.
Device	4.1" H x 5.36" W x 2.21" D (3-gang wide)
Product weight	0.7 lbs (0.3 kg) per unit
Regulatory compliance	CE, c-UL UL, CE**, C-tick, FCC Class A**, ICES, VCCI, Complies with the appropriate requirements of RoHS, WEEE
Product warranty	3 years parts and labor
Everlast power supply warranty	7 years parts and labor
NOTE     All nominal levels are at ±10%.
NOTE     Specifications are subject to change without notice.
(4369-091118-D13)

Versand-Abmessung und -Gewicht
Teilenummer	Höhe	Breite	Tiefe	Gewicht
60-1232-11	10,2 cm	27,2 cm	23,5 cm	1,34 kg
60-1232-13	10,2 cm	27,2 cm	23,5 cm	1,34 kg
60-1232-12	10,2 cm	27,2 cm	23,5 cm	1,34 kg
60-1232-14	10,2 cm	27,2 cm	23,5 cm	1,34 kg