ISM 482

Technische Daten

ISM 482
Video
Routing	8 x 2 matrix
Video input
Number/signal type	8 RGBHV, RGBS, RGsB, RGBcvS, component video, S-video, composite video
Connectors	8 x 5 female BNC
Nominal level	1 Vp-p for Y of component video and S-video, and for composite video 0.7 Vp-p for RGB and for R-Y and B-Y of component video 0.3 Vp-p for C of S-video
Minimum/maximum levels	Analog: 0 V to 1.0 Vp-p with no offset
Impedance	75 ohms
Horizontal frequency	Autoscan 15 kHz to 100 kHz (RGB)
Vertical frequency	Autoscan 50 Hz to 100 Hz
Resolution range	Autoscan 720x525 to 1600x1200* *Input resolutions above 1400x1050 are undersampled.
Video processing
Decoder	9 bit digital
Digital sampling	24 bit, 8 bits per color; 13.5 MHz standard (video), 140 MHz standard (RGB)
Colors	16.78 million
Horizontal filtering	4 levels
Vertical filtering	8 levels
Video output
Number/signal type	2 scaled RGBHV, RGBS, 1 optional DVI
Connectors	2 x 5 BNC female, (2) 15-pin HD female
Nominal level	0.7 Vp-p for RGB
Minimum/maximum levels	0 V to 0.7 Vp-p
Impedance	75 ohms
Scaled resolutions	640x4801,3,4,6, 800x6001,3,4,6, 832x6243,4,6, 848x4803,6,852x4803,6, 1024x7681,3,4,5,6, 1280x7681,2,3,6, 1280x8001,3,6, 1280x10241,3, 1360x7653,6, 1365x10243,6, 1366x7683,6, 1400x10501,3,6, 576p1,6, 720p3,6, 1080p3,6, 1080i1,3,6 1 = at 50 Hz, 2 = at 56 Hz, 3 = at 60 Hz, 4 = at 75 Hz, 5 = 85 Hz, 6 = locked to the refresh rate of input #1 (Accu-RATE Frame Lock™)
NOTE     For output resolutions with less than 1024 pixels horizontally, the optional DVI output's true horizontal resolution is limited to 1024 pixels.  For the 1365x1024, 1080p, and 1080i output resolutions, the optional DVI output's true horizontal resolution is limited to 1280 pixels.  The DVI card outputs all other selected resolutions normally.
NOTE     For the output resolutions listed below, the total pixel and active pixel values of the RGBHV outputs are reduced:   1365x1024: 1280 active pixels   1080i: 1280 active pixels   1080p: 1280 active pixels The sync timings and line widths are correct and most displays recognize the rate correctly.
Return loss	-30 dB @ 5 MHz
DC offset	±5 mV with input at 0 offset
Sync
Input type	Autodetect (RGBHV, RGBS, RGsB), RGBcvS, and component
Output type	RGBHV, RGBS
Standards	NTSC 3.58, NTSC 4.43, PAL, SECAM
Input level	2.75 V to 5.0 Vp-p for RGBHV or RGBS 0.6 Vp-p for component video tri-level sync 0.3 Vp-p for component video bi-level sync or RGsB
Output level	TTL: 5.0 Vp-p, unterminated
Input impedance	510 ohms
Output impedance	75 ohms
Max. input voltage	5.0 Vp-p
Max. propagation delay	20 ns
Polarity	Positive or negative (selectable)
Audio
Routing	8 x 2 stereo matrix
Gain	Unbalanced output: 0 dB; balanced output: +6 dB
Frequency response	20 Hz to 20 kHz, ±0.05 dB
THD + Noise	0.03% @ 1 kHz at nominal level
S/N	>90 dB at maximum output (unweighted)
Crosstalk	<-80 dB @ 1 kHz, fully loaded
Stereo channel separation	>90 dB @ 1 kHz
CMRR	>75 dB @ 20 Hz to 20 kHz
Audio input
Number/signal type	8 stereo, balanced/unbalanced
Connectors	(8) 3.5 mm captive screw connectors, 5 pole
Impedance	>10k ohms unbalanced/balanced, DC coupled
Nominal level	Configurable: -60 dBV (1 mVrms), +4 dBu (1.23 Vrms), 0 dBu (0.775 Vrms), -10 dBV (316 mVrms), -20 dBV (100 mVrms)
Maximum level	+19.5 dBu, (balanced or unbalanced) at 1%THD+N
Input gain adjustment	–24 dB to +9 dB, adjustable per input
NOTE     0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu
Audio output
Number/signal type	2 stereo, balanced/unbalanced
Connectors	(2) 3.5 mm captive screw connectors, 5 pole
Impedance	50 ohms unbalanced, 100 ohms balanced
Gain error	±0.1 dB channel to channel
Maximum level (Hi-Z)	>+21 dBu, balanced or unbalanced at 1% THD+N
Maximum level (600 ohm)	>+15 dBm, balanced or unbalanced at 1% THD+N
Control/remote — switcher/scaler
Serial control port	RS-232, 9-pin female D connector
Baud rate and protocol	9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configurations	2 = Tx, 3 = Rx, 5 = GND
Ethernet control port	1 RJ-45 female connector
Ethernet data rate	10/100Base-T, half/full duplex with autodetect
Ethernet protocol	ARP, ICMP (ping), IP, TCP, Telnet
Program control	Extron's control/configuration program for Windows® Extron's Simple Instruction Set (SIS™) Microsoft® Internet Explorer®, Telnet
General
Power	100 VAC to 240 VAC, 50-60 Hz, 60 watts, internal
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling	Fan, right to left (as viewed from the front panel)
Mounting
Rack mount	Yes
Enclosure type	Metal
Enclosure dimensions	5.25" H x 17.5" W x 11.2" D (3U high, full rack wide) (13.3 cm H x 48.3 cm W x 28.4 cm D) (Depth excludes connectors and knobs.  Width excludes rack ears.)
Product weight	11.2 lbs (5.1 kg)
Shipping weight	17 lbs (8 kg)
DIM weight
USA/Canada	18 lbs (9 kg)
International	21 lbs (10 kg)
Vibration	ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance
Safety	CE, c-UL, UL
EMI/EMC	CE, FCC Class B
Product warranty	3 years parts and labor
NOTE     All nominal levels are at ±10%.
NOTE     Specifications are subject to change without notice.
(8.0-011713-D15)

Versand-Abmessung und -Gewicht
Teilenummer	Höhe	Breite	Tiefe	Gewicht
60-425-01	26,7 cm	38,4 cm	57,2 cm	7,62 kg