MTP U R RSA SEQ
EUR
1346.40
€ 1346.40
Hersteller
Extron
Art.Nr.
60-869-01
EAN
60-869-01
Produktbeschreibung
Hauptmerkmale
- Empfängt RGBHV, Komponenten-Video, S-Video, FBAS-Video, Audio und RS-232 über ein einziges CAT 5-Kabel
- Automatische Weiterleitung des UTP-Signals zu den entsprechenden Anschlüssen
- Kompatibel mit Kreuzschienen der MTPX und MTPX Plus-Serie, sowie mit allen Sendern der MTP-Serie
- Individuelle Korrektur der Laufzeitdifferenz für jede Farbe
Modell | Beschreibung der Version | Teilenummer | |
---|---|---|---|
MTP U R RSA SEQ | VGA, Video, Audio & RS-232 mit Laufzeitdifferenz-Equalizer | 60-869-01 |
Technische Daten
Technische Daten
-
MTP U R Series Video Gain Unity Video input Number/signal type 1 set of proprietary analog signals Connectors 1 female RJ-45 Video output Number/signal type 1 RGBHV, RGBS, component video (bi-level and tri-level), S-video, composite video (follows input type) Connectors MTP U R RSA SEQ, MTP C7 U R RSA SEQ 1 female 15-pin HD for RGB
3 female BNC for Y, R-Y, B-Y
1 female 4-pin mini DIN for S-video (Y/C)
1 female BNC for composite videoAll other models 1 female 15-pin HD for RGB or Y, R-Y, B-Y
1 female 4-pin mini DIN for S-video (Y/C)
1 female BNC for composite videoNominal level 1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-videoMinimum/maximum levels 0.8 V to 1.2 Vp-p Impedance 75 ohms (during video output only) Return loss <-30 dB @ 5 MHz (during video output only) DC offset <±20 mV with input at 0 offset Skew compensation 62 ns Maximum resolution Up to 1920x1200 or 2048x1080 or 1080p at 300'
Up to 1024x768 at 600'NOTE Refer to the user's guide for the maximum distances recommended for specific resolutions. Sync Output type RGBHV, RGBS Standards NTSC 3.58, NTSC 4.43, PAL, SECAM Output level 4.0 V to 5.0 Vp-p, unterminated Output impedance 87 ohms (24 mA) Polarity Positive or negative (selectable) Audio — MTP U R RSA SEQ, MTP U R A, MTP C7 U R RSA SEQ Gain Unbalanced output: 0 dB; balanced output: +6 dB Frequency response 20 Hz to 20 kHz, ±1 dB THD + Noise 0.15% @ 1 kHz, 0.3% @ 20 kHz at nominal level S/N >70 dB at maximum output (unweighted) Audio input — MTP U R RSA SEQ, MTP U R A, MTP C7 U R RSA SEQ — See MTP Series transmitters' audio output specifications Number/signal type 1 set of proprietary analog signals Connectors 1 female RJ-45 NOTE 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu Audio output — MTP U R RSA SEQ, MTP U R A, MTP C7 U R RSA SEQ Number/signal type 2 mono, balanced/unbalanced Connectors (1) 3.5 mm captive screw connector, 5 pole Impedance 50 ohms unbalanced, 100 ohms balanced Gain error ±1 dB channel to channel Control/remote — external device (pass-through, unidirectional or bidirectional) (RS and RSA models) Serial control port input/output RS-232 via (1) 3.5 mm, 3 pole captive screw connector Baud rates Up to 38400 bps at up to 600' (183 m) NOTE Higher data rates and distances are possible. Performance varies based on baud rate and cable length. Protocol Data bits = 5 - 8
Stop bits = 1 or 2
Parity = odd, even, none
Flow control = XON, XOFF, noneNOTE Protocol is mirrored between the transmitter and the receiver. Serial control pin configuration Captive screw connectors: 1 = Tx, 2 = Rx, 3 = GND General Recommended cable type MTP C7 U R RSA SEQ CAT 7 (shielded) or Extron STP201 All other models CAT 5/5e/6 (shielded or unshielded) NOTE Shielded twisted pair cable provides added protection from outside interference and increases overall signal transmission distance. Extron strongly recommends using shielded twisted pair for optimal performance. Power supply External
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 1 A, 12 wattsPower input requirements 12 VDC, 0.5 A Temperature/humidity Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensingCooling Convection, vents on top and sides Mounting Rack mount Yes, with optional 1U rack shelf Furniture mount Yes, with optional mini under-desk mounting kit Pole mount Yes, with optional pole mounting kit Enclosure type Metal Enclosure dimensions 1.7" H x 4.3" W x 3.0" D (1U high, quarter rack wide)
(4.3 cm H x 10.9 cm W x 7.6 cm D)
(Depth excludes connectors.)Product weight 0.6 lbs (0.3 kg) Shipping weight 2 lbs (1 kg) Vibration ISTA 1A in carton (International Safe Transit Association) Regulatory compliance Safety CE, c-UL, UL EMI/EMC CE, C-tick, FCC Class A, ICES, VCCI Product warranty 3 years parts and labor NOTE All nominal levels are at ±10%. NOTE Specifications are subject to change without notice. (8.0-060811-D11) Versand-Abmessung und -Gewicht Teilenummer Höhe Breite Tiefe Gewicht 60-869-01 6,4 cm 22,2 cm 31,3 cm 0,91 kg