XTP SFR HD 4K

Technische Daten

XTP SFR HD 4K
specification
Frame rate 1	24, 25, 30, 50, or 60 fps
Chroma sampling 1	4:4:4, 4:2:2, or 4:2:0
Color bit depth 1	8 bits per color
Signal type	DisplayPort 1.1, DVI 1.0, HDMI 1.4a, HDCP 1.4
Max. video data rate	8.91 Gbps (2.97 Gbps per color)
NOTE     1Subject to the maximum data rate limit. Use our calculator at www.extron.com/4Kdatarate to determine video parameters supported by this data rate.
NOTE     The XTP SFR HD 4K scaling receiver can be used with XTP transmitters, with a fiber optic cable linking the transmitter and receiver, or with other Extron XTP products.
NOTE     These receivers are class 1 laser products. They meet the safety regulations of IEC 60825-1.
Video
Gain	Unity
Resolution range	Up to 2560x1600 @ 60 Hz* or 4K (4096x2160) @ 24 Hz, UHD (3840x2160) @ 30 Hz, UHD @ 60 Hz with 4:2:0 chroma subsampling** * reduced blanking ** bypass mode only
Signal type	Single-link HDMI (or DVI-D or DisplayPort)
Color bit depth	8, 10, or 12 bits — subject to the maximum data rate limit
Maximum data rate	8.91 Gbps (2.97 Gbps per color)
Maximum pixel clock	300 MHz (600 MHz for 4K rates with 4:2:0 chroma subsampling)
Formats	RGB and YCbCr digital video
Standards	DisplayPort 1.1, DVI 1.0, HDMI 1.4a, HDCP 1.4
Optical fiber interconnection between transmitter and receiver
Number/signal type	1 set of proprietary signals
Connectors	1 LC fiber connector
Operating distance
NOTE     Operating distance is approximate. These are typical maximum distances that may vary depending on factors such as fiber type, fiber bandwidth, connector splicing, losses, modal or chromatic dispersion, environmental factors, and kinks.
Singlemode	10 km (6.21 miles) with singlemode cable
Multimode	400 m (1312') with 50 µm OM3 2000 MHz bandwidth laser optimzed multimode cable 700 m (2297') with 50 µm OM4 4700 MHz bandwidth laser optimzed multimode cable
NOTE     Multimode units are compatible with OM1 and OM2 multimode cables, but at reduced operating distances.
Nominal peak wavelength
Singlemode	1490 nm, 1550 nm, 1310 nm
Multimode	850 nm, 980 nm, 780 nm
Data rate	8.5 Gbps
Transmission power
Singlemode	-6 dBm, typical
Multimode	-5 dBm, typical
Maximum receiver sensitivity
Singlemode	-15 dBm, typical
Multimode	-13 dBm, typical
Optical loss budget
Singlemode	9 dB, maximum
Multimode	8 dB, maximum
Video processing
Digital sampling	24 bit, 8 bits per color, 297 MHz standard
Colors	16.78 million
Video output
Number/signal type	1 single link HDMI (or DVI-D)
Connectors	1 female HDMI type A
Scaled resolutions	640x4808, 800x6008, 1024x7688, 1280x7688, 1280x8008, 1280x10248, 1360x7688, 1366x7688, 1400x10508, 1440x9008, 1600x9008, 1600x12008, 1680x10508, 1920x12008, 2048x12008, 2048x15368, 2560x10808, 2560x14408, 2560x16008, bypass* HDTV: 480p7,8, 576p6, 720p3,4,5,6,7,8, 1080i6,7,8, 1080p1,2,3,4,5,6,7,8, 1920x21601,2,3,4,5,6,7,8, 2048x10801,2,3,4,5,6,7,8, 2048x21601,2,3,4,5,6,7,8, 3840x21601,2,3,4,5, bypass* 1 = 23.98 Hz, 2 = 24 Hz, 3 = 25 Hz, 4 = 29.97 Hz, 5 = 30 Hz, 6 = 50 Hz, 7 = 59.94 Hz, 8 = 60 Hz.
NOTE     * When the output resolution is set to "bypass," the input signal is output without being scaled.
Audio
Gain	Unbalanced output: 0 dB; balanced output: +6 dB
Frequency response	20 Hz to 20 kHz, ±0.5 dB
THD + Noise	<0.1%, 20 Hz - 20 kHz at nominal level
S/N	>90 dB, at maximum balanced output (unweighted)
Crosstalk	?-80 dB @ 1 kHz, fully loaded
Stereo channel separation	>80 dB @ 1 kHz
Sampling rates	32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 192 kHz
Bit depths	16, 20, 24 bit
NOTE     0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu
Audio output
Number/signal type	1 analog stereo, balanced/unbalanced 1 digital audio, embedded with HDMI output 1 digital audio via S/PDIF output connector
Connectors	(1) 3.5 mm captive screw connector, 5 pole 1 female HDMI type A (shared with video output) 1 female RCA jack (tip, ring)
Supported formats
HDMI	LPCM up to 7.1/24-bit/192 kHz, Dolby Atmos™, Dolby TrueHD, Dolby Digital Plus™, Dolby Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-HD Master Audio™, DTS-HD, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS Digital Surround 5.1
S/PDIF	2-channel LPCM up to 48 kHz, Dolby® Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS Digital Surround 5.1
Analog	Analog stereo
Impedance
Analog	50 ohms unbalanced, 100 ohms balanced
S/PDIF	75 ohms
Maximum level (Hi-Z)	>+12 dBV balanced; +6 dBV unblanced
Gain error	±0.5 dB channel to channel
Volume control	-100 dB to 0 dB (control 0 to 100 in 1 dB steps)
NOTE     Attenuation = volume number minus 64. The default is 0 dB = volume number 64.
Communications — receiver
Serial control port	1 bidirectional RS-232: 1 rear panel 3.5 mm captive screw connector, 3 pole
Baud rate and protocol	9600 (default) to 115200 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = Gnd
USB control ports	1 front panel female mini USB B
USB standards	USB 2.0, low speed
Program control	Extron control/configuration program for Windows® Extron Simple Instruction Set (SIS™)
Communications — external device (pass-through, unidirectional or bidirectional)
Serial control pass-through port	RS-232 (±5 V) via (1) 3.5 mm, 5 pole captive screw connector (uses 3 poles) (connector is shared with the IR control port)
Baud rates	Up to 115200 baud
Protocol	Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = Gnd
IR control port	(1) 3.5 mm, captive screw connector, 5 pole (uses 3 poles) (connector is shared with the RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 56 kHz
IR control pin configuration	3 = Gnd, 4 = IR Tx, 5 = IR Rx
Ethernet pass-through port	1 female RJ-45 connector
Ethernet data rate	10/100Base-T, full duplex with autodetect
Relay number/type	2 normally open relays
Relay control connectors	(1) 3.5 mm captive screw connectors, 4 pole
Relay control contact rating	24 V, 1 A
General
External power supply	External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1.5 A, 18 watts
Power consumption
Device	7.6 watts
Device and power supply	9.4 watts
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling	Convection, no vents
Thermal dissipation
Device	24.6 BTU/hr
Device and power supply	30.8 BTU/hr
Mounting
Rack mount	Yes, with optional 1U rack shelf
Furniture mount	Yes, with optional under-desk mounting kit
Pole mount	Attachable to a projector mount pole with optional PMK 350 kit
Enclosure type	Metal
Enclosure dimensions	1.0" H x 8.75" W x 6.0" D (half rack wide) (2.5 cm H x 22.2 cm W x 15.2 cm D) (Depth excludes connectors.)
Product weight	1.6 lbs (0.7 kg)
Vibration	ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance	CE, c-UL, UL, IEC 60825-1, C-tick, FCC Class A, ICES, VCCI Complies with the appropriate requirements of RoHS and WEEE.
Product warranty	3 years parts and labor
Everlast power supply warranty	7 years parts and labor
NOTE     All nominal levels are at ±10%.
NOTE     Specifications are subject to change without notice.
(4446-D11)

Versand-Abmessung und -Gewicht
Teilenummer	Höhe	Breite	Tiefe	Gewicht
60-1278-21	10,2 cm	27,2 cm	23,5 cm	1,27 kg
60-1278-22	10,2 cm	27,2 cm	23,5 cm	1,27 kg