XTP SR HD 4K

Technische Daten

XTP SR HD 4K
specification
Frame rate 1	24, 25, 30, 50, or 60 fps
Chroma sampling 1	4:4:4, 4:2:2, or 4:2:0
Color bit depth 1	8 bits per color
Signal type	DisplayPort 1.1, DVI 1.0, HDMI 1.4, HDCP 2.2
Max. video data rate	10.2 Gbps (3.4 Gbps per color)
NOTE     1Subject to the maximum data rate limit. Use our calculator at www.extron.com/4Kdatarate to determine video parameters supported by this data rate.
NOTE     The XTP SR HD 4K scaling receiver can be used with other Extron XTP products, with twisted pair cables linking the units.
Video
Gain	Unity
Resolution range	Up to 2560x1600 @ 60 Hz* or 4K (4096x2160) @ 30 Hz, UHD (3840x2160) @ 30 Hz, 4K/UHD @ 60 Hz with 4:2:0 chroma subsampling** * reduced blanking ** bypass mode only
Signal type	Single-link HDMI (or DVI-D or DisplayPort)
Maximum data rate	10.2 Gbps (3.4 Gbps per color)
Maximum pixel clock	300 MHz (600 MHz for 4K rates with 4:2:0 chroma subsampling)
Formats	RGB and YCbCr digital video
Standards	DisplayPort 1.1, DVI 1.0, HDMI 1.4; HDCP 2.2
Interconnection between transmitter and receiver
Connectors	1 female RJ-45 per unit
Termination standards	TIA/EIA T568B
Signal transmission distance	330' (100 m) using shielded twisted pair or XTP DTP 24 cable
Cable requirements	Solid conductor, 24 AWG or better
Cable recommendations	400 MHz bandwidth, STP (Shielded Twisted Pair)
NOTE     Extron XTP DTP 24 shielded twisted pair cable is strongly recommended for optimal performance.
Video processing
Digital sampling	24 bit, 8 bits per color, 297 MHz standard
Colors	16.78 million
Video output
Number/signal type	1 single link HDMI (or DVI-D)
Connectors	1 female HDMI type A
Scaled resolutions	640x4808, 800x6008, 1024x7688, 1280x7688, 1280x8008, 1280x10248, 1360x7688, 1366x7688, 1400x10508, 1440x9008, 1600x9008, 1600x12008, 1680x10508, 1920x12008, 2048x12008, 2048x15368, 2560x10808, 2560x14408, 2560x16008, bypass* HDTV: 480p7,8, 576p6, 720p3,4,5,6,7,8, 1080i6,7,8, 1080p1,2,3,4,5,6,7,8, 1920x21601,2,3,4,5,6,7,8, 2048x10801,2,3,4,5,6,7,8, 2048x21601,2,3,4,5,6,7,8, 3840x21601,2,3,4,5, bypass* 1 = 23.98 Hz, 2 = 24 Hz, 3 = 25 Hz, 4 = 29.97 Hz, 5 = 30 Hz, 6 = 50 Hz, 7 = 59.94 Hz, 8 = 60 Hz.
NOTE     * When the output resolution is set to "bypass," the input signal is output without being scaled.
Audio
Gain	Unbalanced output: 0 dB; balanced output: +6 dB
Frequency response	20 Hz to 20 kHz, ±0.5 dB
THD + Noise	<0.1%, 20 Hz - 20 kHz at nominal level
S/N	>90 dB, at maximum balanced output (unweighted)
Crosstalk	?-80 dB @ 1 kHz, fully loaded
Stereo channel separation	>80 dB @ 1 kHz
Sampling rates	32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 192 kHz
Bit depths	16, 20, 24 bit
Audio output
Number/signal type	1 analog stereo, balanced/unbalanced 1 digital audio, embedded with HDMI output 1 digital audio via S/PDIF output connector
Connectors	(1) 3.5 mm captive screw connector, 5 pole 1 female HDMI type A (shared with video output) 1 female RCA jack (tip, ring)
Supported formats
HDMI	LPCM up to 7.1/24-bit/192 kHz, Dolby Atmos®, Dolby® TrueHD, Dolby Digital Plus™, Dolby Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-HD Master Audio™, DTS-HD, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS Digital Surround 5.1, DTS 2 Channel
S/PDIF	LPCM up to 7.1/24-bit/192 kHz, Dolby Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS Digital Surround 5.1, DTS 2 Channel
Analog	Analog stereo audio
Impedance
Analog	50 ohms unbalanced, 100 ohms balanced
Digital	75 ohms (for S/PDIF output)
Maximum level (Hi-Z)	>+12 dBV balanced; +6 dBV unblanced
Gain error	±0.5 dB channel to channel
Volume control	-100 dB to 0 dB (control 0 to 100 in 1 dB steps)
NOTE     Attenuation = volume number minus 64. The default is 0 dB = volume number 64.
NOTE     0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu
Communications — receiver
Serial control port	1 bidirectional RS-232: 1 rear panel 3.5 mm captive screw connector, 3 pole
Baud rate and protocol	9600 (default) to 115200 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = Gnd
USB control ports	1 front panel female mini USB B
USB standards	USB 2.0, low speed
Program control	Extron control/configuration program for Windows® Extron Simple Instruction Set (SIS™)
Communications — external device (pass-through, unidirectional or bidirectional)
Serial control port input/output	1 set of proprietary signals on a female RJ-45 jack
Serial control port output/input	RS-232 (±5 V) via (1) 3.5 mm, 5 pole captive screw connector (uses 3 poles) (connector is shared with IR control port)
Baud rates	Up to 115200 baud
Protocol	Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = Gnd
IR control port	(1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 56 kHz
IR control pin configuration	3 = Gnd, 4 = IR Tx, 5 = IR Rx
Ethernet pass-through port	1 female RJ-45 connector
Ethernet data rate	10/100Base-T, half/full duplex with autodetect
Relay number/type	2 normally open relays
Relay control connectors	(1) 3.5 mm captive screw connectors, 4 pole
Relay control contact rating	24 V, 1 A
General
External power supply	External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1.5 A, 18 watts
Power consumption
Device	11.2 watts, 12 VDC
Device and power supply	12.6 wats, 12 VDC
NOTE     The XTP receiver can be powered either locally by an external power supply or remotely using an optional power injector or XTP CrossPoint matrix switcher.
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling	Convection, vents on sides and top
Thermal dissipation
Device	37.0 BTU/hr
Device and power supply	41.9 BTU/hr
Mounting
Rack mount	Yes, with optional 1U rack shelf
Furniture mount	Yes, with optional under-desk mounting kit
Pole mount	Attachable to a projector mount pole with optional PMK 350 kit
Enclosure type	Metal
Enclosure dimensions	1.0" H x 8.68" W x 6.0" D (half rack wide) (2.5 cm H x 22.1 cm W x 15.2 cm D) (Depth excludes connectors.)
Product weight	1.6 lbs (0.7 kg)
Vibration	ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance
Safety	CE, c-UL, UL
EMI/EMC	CE**, C-tick, FCC Class A**, ICES, VCCI
Environmental	Complies with the appropriate requirements of RoHS, WEEE.
NOTE     **CE and FCC testing is conducted with STP (shielded twisted pair) cable.
Product warranty	3 years parts and labor
Everlast power supply warranty	7 years parts and labor
NOTE     All nominal levels are at ±10%.
NOTE     Specifications are subject to change without notice.
(3839-120216-D2)