XTP T USW 103 4K

Technische Daten

XTP T USW 103 4K
specification
Frame rate 1	24, 25, 30, 502, or 602 fps
Chroma sampling 1	4:4:4, 4:2:2, or 4:2:02
Color bit depth 1	8 bits per color
Signal type	DisplayPort 1.1, DVI 1.0, HDMI 1.4, HDCP 1.4 and 2.2
Max. video data rate
HDMI	10.2 Gbps (3.4 Gbps per color)
DisplayPort	10.8 Gbps (2.7 Gbps per lane)
NOTE     1Subject to the maximum data rate limit. Use our calculator (www.extron.com/4Kdatarate) to determine video parameters supported by this data rate. 2Applicable to HDMI signals only.
NOTE     The XTP T USW 103 4K switcher can be used with other Extron XTP products, with twisted pair cables connecting the units.
Video
VGA
Gain	Unity
Resolution range	Up to 1920x1200* or 1080p (HDTV) * reduced blanking
HDMI
Maximum data rate	10.2 Gbps (3.4 Gbps per color)
Maximum pixel clock	300 MHz (600 MHz for 4K rates with 4:2:0 chroma subsampling)
Resolution range	Up to 2560x1600 @ 60 Hz*, or 4K (4096x2160) @ 30 Hz, UHD (3840x2160) @ 30 Hz, 4K/UHD @ 60 Hz with 4:2:0 chroma subsampling * reduced blanking
Formats	RGB and YCbCr digital video
Standards	DisplayPort 1.1, DVI 1.0, HDMI 1.4, HDCP 1.4 and 2.2
DisplayPort
Maximum data rate	10.8 Gbps (2.7 Gbps per lane)
Maximum pixel clock	300 MHz
Resolution range	Up to 2560x1600 @ 60 Hz*, or 4K (4096x2160) @ 30 Hz, UHD (3840x2160) @ 30 Hz, * reduced blanking
Formats	RGB and YCbCr digital video
Standards	DisplayPort 1.1, HDCP 1.3
NOTE     Only Single Stream Transport (SST) is supported.
Video input
Number/signal type	1 analog RGBHV 1 single link HDMI (or DVI-D or DisplayPort) 1 DisplayPort
Connectors	1 female 15-pin HD 1 female HDMI type A 1 female DisplayPort
Nominal level	0.7 Vp-p for RGB
Minimum/maximum levels	0.3 V to 1.45 Vp-p
Impedance	75 ohms
Horizontal frequency	30 kHz to 100 kHz
Vertical frequency	24 Hz to 120 Hz
Video output — switched, local
Number/signal type	1 single link HDMI (or DVI-D)
Connectors	1 female HDMI type A
Shielded twisted pair interconnection
Connectors	1 female RJ-45 per unit
Termination standards	TIA/EIA T568B
Signal transmission distance	330' (100 m) using shielded twisted pair or XTP DTP 24 cable
Cable requirements	Solid conductor, 24 AWG or better
Cable recommendations	400 MHz bandwidth, STP (shielded twisted pair)
NOTE     Extron XTP DTP 24 shielded twisted pair cable is strongly recommended for optimal performance.
Audio
Gain
Range	Adjustable, -18 dB to +24 dB
Default	Unbalanced output: 0 dB; balanced output +6 dB
Frequency response	20 Hz to 20 kHz, ±0.05 dB
THD + Noise	0.1% @ 1 kHz at nominal level
S/N	>90 dB, at maximum output, balanced (unweighted)
Crosstalk	?-80 dB @ 1 kHz, fully loaded
Stereo channel separation	>80 dB @ 1 kHz
Sampling rates	32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 192 kHz
Bit depths	16, 20, 24 bit
Audio input
Number/signal type	1 analog stereo, unbalanced or 1 digital audio, de-embedded from HDMI 1 digital audio, de-embedded from DisplayPort
Connectors	1 female 3.5 mm mini stereo jack 1 female HDMI type A (shared with video input) 1 female DisplayPort (shared with video input)
Source formats	LPCM up to 7.1/24-bit/192 kHz, Dolby Atmos™, Dolby TrueHD, Dolby Digital Plus™, Dolby Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-HD Master Audio™, DTS-HD, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS Digital Surround 5.1, DTS 2 Channel, analog stereo
Impedance	>10k ohms, unbalanced, DC coupled
Nominal level	-10 dBV (316 mVrms) unbalanced
Maximum level	+7 dBv unbalanced
NOTE     0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu
Audio output
Number/signal type	1 digital audio, embedded with HDMI output
Connectors	1 female HDMI type A (shared with video output)
Source formats	LPCM up to 7.1/24-bit/192 kHz, Dolby Atmos™, Dolby TrueHD, Dolby Digital Plus™, Dolby Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-HD Master Audio™, DTS-HD, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS Digital Surround 5.1, DTS 2 Channel
NOTE     0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu
Communications — switcher
Serial control port	1 bidirectional RS-232: 1 rear panel 3.5 mm captive screw connector, 3 pole
Baud rate and protocol	9600 (default) to 115200 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = Gnd
Contact closure	(1) 3.5 mm captive screw connector, 4 pole
Contact closure pin configuration	1 = input 1, 2 = input 2, 3 = input 3, 4 = GND
Tally output	3 tally outputs on (1) 3.5 mm captive screw connector, 4 pole
Tally pin configuration	1 = Input 1 tally ground, 2 = Input 2 tally ground, 3 = Input 3 tally ground, 4 = +5 V
USB control port	1 front panel female mini USB B
USB standards	USB 2.0, low speed
Program control	Extron control/configuration program for Windows® Extron Simple Instruction Set (SIS™)
Communications — external device (pass-through, unidirectional or bidirectional)
Serial control pass-through port	RS-232 (±5 V) via (1) 3.5 mm, 5 pole captive screw connector (uses 3 poles) (connector is shared with the IR control port)
Baud rates	Up to 115200 baud
Protocol	Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = Gnd
IR control port	(1) 3.5 mm, captive screw connector, 5 pole (uses 3 poles) (connector is shared with the RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 56 kHz
IR control pin configuration	3 = GND, 4 = IR Tx, 5 = IR Rx
Ethernet pass-through port	1 female RJ-45 connector
Ethernet data rate	10/100Base-T, half/full duplex with autodetect
General
Power supply	External Input: 100 to 240 VAC, 50-60 Hz Output: 12 VDC, 1.5 A, 18 watts
Power consumption
Device	16.5 watts, 12 VDC
Device and power supply	18.2 watts, 12 VDC
NOTE     The XTP T USW 103 4K requires a locally connected power supply.
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling	Convection, vents on sides and top
Thermal dissipation
Device	55.3 BTU/hr
Device and power supply	61.1 BTU/hr
Mounting
Rack mount	Yes, with optional 1U high rack shelf
Furniture mount	Yes, with optional under-desk mounting kit
Enclosure type	Metal
Enclosure dimensions	1.66" H x 8.68" W x 8.5" D (half rack wide) (4.2 cm H x 22.1 cm W x 21.5 cm D) (Depth excludes connectors.)
Product weight	2.7 lbs (1.2 kg)
Vibration	ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance
Safety	CE, c-UL, UL
EMI/EMC	CE, C-tick, FCC Class A, ICES, VCCI
Environmental	Complies with the appropriate requirements of RoHS, WEEE.
Product warranty	3 years parts and labor
Everlast power supply warranty	7 years parts and labor
NOTE     All nominal levels are at ±10%.
NOTE     Specifications are subject to change without notice.
(4124-D6)

Versand-Abmessung und -Gewicht
Teilenummer	Höhe	Breite	Tiefe	Gewicht
60-1717-12	12,1 cm	33,7 cm	36,2 cm	1,81 kg