XTP T UWP 202 4K

Technische Daten

XTP T UWP 202 4K
specification
Frame rate 1	24, 25, 30, 50, or 60 fps
Chroma sampling 1	4:4:4, 4:2:2, or 4:2:0
Color bit depth 1	8 bits per color
Signal type	DisplayPort 1.1, DVI 1.0, HDMI 1.4, HDCP 2.2
Max. video data rate	10.2 Gbps (3.4 Gbps per color)
NOTE     1Subject to the maximum data rate limit. Use our calculator at www.extron.com/4Kdatarate to determine video parameters supported by this data rate.
NOTE     The XTP T UWP 202 4K transmitter can be used with other Extron XTP products, with twisted pair cables connecting the units.
Video
Gain	Unity
Resolution range
Digital	Up to 2560x1600 @ 60 Hz*, or 4K (4096x2160) @ 30 Hz, UHD (3840x2160) @ 30 Hz, 4K/UHD @ 60 Hz with 4:2:0 chroma subsampling * reduced blanking
Analog	Up to 1920x1200* or 1080p (HDTV) * reduced blanking
Signal type	Single-link HDMI (or DVI-D or DisplayPort)
Maximum data rate	10.2 Gbps (3.4 Gbps per color)
Maximum pixel clock	300 MHz (600 MHz for 4K rates with 4:2:0 chroma subsampling)
Formats	RGB and YCbCr digital video
Standards	DisplayPort 1.1, DVI 1.0, HDMI 1.4; HDCP 2.2
Video input
Number/signal type	1 analog RGBHV 1 single link HDMI (or DVI-D or DisplayPort)
Connectors	1 female 15-pin HD 1 female HDMI type A
Nominal level	0.7 Vp-p for RGB
Minimum/maximum levels	0.3 V to 1.45 V p-p
Impedance	75 ohms
Horizontal frequency	30 kHz to 100 kHz
Vertical frequency	24 Hz to 120 Hz
Shielded twisted pair interconnection
Connectors	1 female RJ-45 per unit
Termination standards	TIA/EIA T568B
Signal transmission distance	330' (100 m) using shielded twisted pair or XTP DTP 24 cable
Cable requirements	Solid conductor, 24 AWG or better
Cable recommendations	400 MHz bandwidth, STP (Shielded Twisted Pair)
NOTE     Extron XTP DTP 24 shielded twisted pair cable is stongly recommended for optimal performance.
Audio
Gain
Range	Adjustable, -18 dB to +24 dB
Default	Unbalanced output: 0 dB; balanced output +6 dB
Frequency response	20 Hz to 20 kHz, ±0.05 dB
THD + Noise	0.01% @ 1 kHz at nominal level
S/N	>90 dB, at maximum output, balanced (unweighted)
Crosstalk	?-80 dB @ 1 kHz, fully loaded
Stereo channel separation	>80 dB @ 1 kHz
Sampling rates	32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 192 kHz
Bit depths	16, 20, 24 bit
Audio input
Number/signal type	1 analog stereo, unbalanced or 1 digital audio, de-embedded from HDMI
Connectors	1 female 3.5 mm mini stereo jack 1 female HDMI type A (shared with video input)
Source formats	LPCM up to 7.1/24-bit/192 kHz, Dolby Atmos®, Dolby® TrueHD, Dolby Digital Plus™, Dolby Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-HD Master Audio™, DTS-HD, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS Digital Surround 5.1, DTS 2 Channel, analog stereo
Impedance	>10k ohms unbalanced, DC coupled
Nominal level	-10 dBV (316 mVrms) unbalanced
Maximum level	+7 dBv unbalanced
NOTE     0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu
Communications — transmitter
Serial control port	1 bidirectional RS-232: 1 rear panel 3.5 mm captive screw connector, 3 pole
Baud rate and protocol	9600 (default) to 115200 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = GND
USB control ports	1 front panel female mini USB B
USB standards	USB 2.0, low speed
Program control	Extron control/configuration program for Windows® Extron Simple Instruction Set (SIS™)
Communications — external device (pass-through, unidirectional or bidirectional)
Serial control port input/output	1 set of proprietary signals on a female RJ-45 jack
Serial control port output/input	RS-232 (±5 V) via (1) 3.5 mm, 5 pole captive screw connector (uses 3 poles) (connector is shared with IR control port)
Baud rates	Up to 115200 baud
Protocol	Data bits = 5-8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = GND
IR control port	(1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 40 kHz
IR control pin configuration	3 = GND, 4 = IR Tx, 5 = IR Rx
Ethernet pass-through port	1 female RJ-45 connector
Ethernet data rate	10/100Base-T, half/full duplex with autodetect
NOTE     Ethernet pass-through port is optional and not available for No-LAN models.
General
Power supply	External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1.5 A, 18 watts
Power consumption
Device	TBD
Device and power supply	TBD
NOTE     The XTP transmitter can be powered either locally by an external power supply or remotely using an optional power injector or XTP CrossPoint matrix switcher.
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +104 °F (0 to +40 °C) / 10% to 90%, noncondensing
Cooling	Convection, no vents
Thermal dissipation
Device	TBD
Device and power supply	TBD
Mounting
Furniture or wall mount	Wall or furniture mount in a decorator-style opening.
Enclosure type	Metal
Enclosure dimensions
Faceplate	Two (2.6" H* x 1.3" W x 0.3" D [6.6 cm H* x 3.3 cm W x 0.8 cm D])
Device	2.8" H* x 3.7" W x 1.9" D (7.1 cm H* x 9.4 cm W x 4.8 cm D) (Depth excludes connectors. Fits some 2-gang boxes.) *Height is 4.1" (10.4 cm) including mounting tabs.
Product weight	0.6 lbs (0.3 kg)
Vibration	ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance	CE, c-UL, UL, C-tick, FCC Class A, ICES, VCCI Complies with the appropriate requirements of RoHS and WEEE.
Product warranty	3 years parts and labor
Everlast power supply warranty	7 years parts and labor
NOTE     All nominal levels are at ±10%.
NOTE     Specifications are subject to change without notice.
(4452-D4)

Versand-Abmessung und -Gewicht
Teilenummer	Höhe	Breite	Tiefe	Gewicht
60-1529-13	7,5 cm	26,7 cm	19,1 cm	1,07 kg
60-1530-12	7,5 cm	26,7 cm	19,1 cm	1,06 kg