XTP T VGA

Technische Daten

XTP T VGA
NOTE     The XTP T VGA transmitter and XTP R HDMI receiver can be used together, with twisted pair cables linking the transmitter and receiver, or with other Extron XTP products.
Video
Gain	Unity
Resolution range	Up to 1920x1200 or 1080p (HDTV)
Maximum pixel clock	165 MHz
Formats	RGB, component video, S-video, composite video
Video input and loop-through
Number/signal type	1 analog RGBHV, RGBS, RGsB, RsGsBs, bi-level and tri-level component video (YUVi or YUVp/HDTV), S-video, or composite video input 1 buffered RGBHV, RGBS, RGsB, RsGsBs, bi-level and tri-level component video (YUVi or YUVp/HDTV), S-video, or composite video loop-through
Connectors	2 female 15-pin HD
Nominal level	1 Vp-p for Y of component video and S-video, and for composite video 0.7 Vp-p for RGB and for R-Y and B-Y of component video 0.3 Vp-p for C of S-video
Minimum/maximum levels	Analog: 0.3 V to 1.45 Vp-p with no offset
Impedance	75 ohms
Horizontal frequency	30 kHz to 100 kHz
Vertical frequency	24 Hz to 120 Hz
Interconnection between transmitter and receiver
Connectors	1 female RJ-45 per unit
Termination standards	TIA/EIA T568B
Signal transmission distance	330' (100 m) using shielded twisted pair or XTP DTP 24 cable
Cable requirements	Solid conductor, 24 AWG or better
Cable recommendations	400 MHz bandwidth, STP (Shielded Twisted Pair)
NOTE     Extron XTP DTP 24 shielded twisted pair cable is stongly recommended for optimal performance.
Audio
Gain	Unbalanced output: 0 dB; balanced output: +6
Frequency response	20 Hz to 20 kHz, ±0.5 dB
THD + Noise	<0.1%, 20 Hz - 20 kHz at nominal level
S/N	>90 dB, at maximum balanced output (unweighted)
Crosstalk	?-80 dB @ 1kHz, fully loaded
Stereo channel separation	>80 dB @ 1 kHz
Audio input
Number/signal type	1 analog stereo, balanced/unbalanced or 1 analog stereo, unbalanced
Connectors	(1) 3.5 mm captive screw connector, 5 pole 1 female 3.5 mm mini stereo jack
Impedance	10k ohms unbalanced, 20k ohms balanced
Nominal level	+4 dBu balanced, -10 dBV configurable
Maximum level	+7 dBv unbalanced
Input gain adjustment	-18 dB to +24 dB, 1 dB steps, adjustable
NOTE     0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu
Communications — transmitter
USB control ports	1 front panel female mini USB B
USB standards	USB 2.0, low speed
Program control	Extron control/configuration program for Windows® Extron Simple Instruction Set (SIS™)
Communications — external device (pass-through, unidirectional or bidirectional)
Serial control port input/output	1 set of proprieraey signals on a female RJ-45 jack
Serial control port output/input	RS-232 (±5 V) via (1) 3.5 mm, 5 pole captive screw connector (uses 3 poles) (connector is shared with IR control port)
Baud rates	Up to 115200 baud
Protocol	Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none
Serial control pin configuration	1 = Tx, 2 = Rx, 3 = GND
Ethernet pass-through port	1 female RJ-45 connector
Ethernet data rate	10/100Base-T, half/full duplex with autodetect
IR control port	(1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 40 kHz
IR control pin configuration	3 = GND, 4 = IR Tx, 5 = IR Rx
General
Power supply	External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1.5 A, 18 watts
Power consumption
Device	11.5 watts, 12 VDC
Device and power supply	14.2 watts, 12 VDC
NOTE     Each XTP transmitter or receiver can be powered either locally by an external power supply or remotely using an optional power inserter.
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling	Convection, vents on sides and top
Thermal dissipation
Device	38.9 BTU/hr
Device and power supply	48.1 BTU/hr
Mounting
Rack mount	Yes, with optional 1U high rack shelf
Furniture mount	Yes, with optional under-desk mounting kit
Enclosure type	Metal
Enclosure dimensions	1.0" H x 8.75" W x 6.0" D (half rack wide) (2.5 cm H x 22.2 cm W x 15.2 cm D) (Depth excludes connectors.)
Product weight	1.2 lbs (0.5 kg)
Shipping weight	3 lbs (2 kg)
Vibration	ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance	CE**, c-UL, UL, C-tick, FCC Class A**, ICES, VCCI Complies with the appropriate requirements of RoHS and WEEE.
NOTE     **CE and FCC testing is conducted with STP (shielded twisted pair) cable.
Product warranty	3 years parts and labor
Everlast power supply warranty	7 years parts and labor
NOTE     All nominal levels are at ±10%.
NOTE     Specifications are subject to change without notice.
(4454-D12)

Versand-Abmessung und -Gewicht
Teilenummer	Höhe	Breite	Tiefe	Gewicht
60-1231-12	12,1 cm	28,1 cm	24,5 cm	1,32 kg